Trek II SC-60D-1 Frequency Converter

$ 417.00

Model SC-60D-1 Frequency Conversion Unit

A Frequency Conversion Unit is required to correctly operate 117 volt AC, 60 Hz (American version) HAMMOND Tonewheel Generator organs with other 117 volt AC inputs from 25 Hz to 100 Hz. The Model SC-60D-1 and SC-60D-2 Frequency Conversion Units will convert a non-60 Hz frequency input to a stable 60 Hz frequency for the tone wheel generator organ START and RUN motors. This allows the organ to play in tune even in countries where the available power line frequency is not 60 Hz or in locations where the power line frequency is not stable or accurate. Installation of the Frequency Conversion Unit does not require any additional equipment or changes in the original HAMMOND organ starting procedure.

NOTE: The Frequency Conversion Unit does NOT 'step-down' higher Voltage! In areas with 220 volts power, a step-down transformer or other means must first be used to drop the voltage to 117 volts, prior to tie-in with the Frequency Converter Unit. We can also supply a step-down transformer at extra cost, however it is not normally included with either Frequency Conversion Unit.

REQUIRED POWER SUPPLY INPUT: 117 VOLTS, 25 Hz to 100 Hz OUTPUT: 110 VOLTS 60 HZ

MODEL SC-60D-1:

Designed for self-starting (with one switch to start them) spinet and console HAMMOND Organ Models:

E-100, E-300, H-100, H-300, L-Series, Porta-B, R-100, T-Series, X-77 (can be used with HAMMOND X-66 with addition of Model TR-2-6 Transposer to replace pedal Tone Generator)

SPECIFY ORGAN MODEL WHEN ORDERING!

Related products